page 4
4. Mounting Plate Installation.
ON
OFF
ON
OFF
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch
is turned to the OFF position.
WARNING
: Failure to disconnect power supply prior
to installation may result in serious injury.
Remove existing fixture.
WARNING
: When using an existing outlet box, be
sure the outlet box is securely attached to the
building structure and can support the full weight of
the fan. Ensure outlet box is clearly marked "Suitable
for Fan Support." If not, it must be replaced with an
approved outlet box. Failure to do so can result in
serious injury.
CAUTION
: Be sure outlet box is grounded properly
and that a ground wire (
GREEN
or bare) is present.
Remove 4 lock nuts and flat washers from
mounting plate. Save for later use.
Install mounting plate to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box.* Pull electrical
wiring from outlet box through center hole in the
mounting plate.
*
Note
: It is very important that you use the proper
hardware when installing the mounting plate as
this will support the fan.
3. Installation Preparation.
This fan can be mounted as a
flushmount
on a
regular (no-slope) ceiling
only
.
Downrod
installations are
not
available for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
downrod
installation
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings
blade edge
7 feet
(2.13m)
(76cm)
30
inches
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
12 f
t.
- 20 f
t.
12 ft. - 20 ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
flat washers
mounting plate
lock nuts
spring washers
flat washers
outlet box screws
mounting plate
