page 9
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 for the transmitter.
Note
: The dimmer switch (labeled
D
and
X
) has
been pre-set to the "ON" position (
D
). If you do not
wish to have dimming capability, please move the
switch to the "OFF" position (
X
).
Install 9-volt battery (included) in transmitter and
then replace the battery cover.
IMPORTANT
: Store the transmitter away from
excess heat or humidity. To prevent damage to
transmitter, remove the battery if not used for long
periods.
Restore electrical power and then turn on wall
switch. Within 30 seconds of turning on the wall
switch, press the "OFF" button, located on the front
of the transmitter, for 5 seconds or until lower light
blinks twice. Test the light and fan functions to
confirm the learning process is complete--
see
Section 12
.
NOTE:
Battery is not rechargeable. Remove
batteries with low or no charge and dispose of
properly.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When
disposing of household alkaline batteries, it is best
to check with your local and state recycling or
household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep
battery away from children.
10. Automated Learning Process./Activating Code.
battery
cover
dimmer
switch
dip
switches
TRANSMITTER
(
back
)
TRANSMITTER
(
front
)
