page 6
With the hanging bracket secured to the
outlet box and able to support the fan,
you are now ready to hang your fan. Grab
the fan firmly with two hands. Slide
downrod through opening in hanging
bracket and let hanging ball rest on the
hanging bracket. Turn the hanging ball
slot until it lines up with the hanging
bracket tab.
WARNING
: Failure to align slot in hanging
ball with tab in hanging bracket may
result in serious injury or death.
Tip
: Seek the help of another person to
hold the stepladder in place and to help
lift the fan up to you once you are set on
the ladder.
Tip
: To prepare for threading electrical wires
through downrod, apply small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws at top of motor housing.
Remove pin and clip from downrod (if you have
not already done so). Slide downrod through
canopy, canopy cover and yoke cover.
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke
and re-insert pin and clip that were previously
removed. Tighten yoke set screws securely.
Lower canopy to motor housing.
NOTE
: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
6. Fan Assembly. (cont.)
hanging bracket tab
hanging ball slot
downrod
electrical wiring
canopy
yoke cover
canopy cover
motor housing
pin
clip
yoke set screw
and nut
