WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
When downrod is secured in place on the
hanging bracket,
WIRE THE RECEIVER
with wire
connectors provided as shown in
diagram 1
.
Tip
: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire
connectors into outlet box. Let antenna rest
outside of hanging bracket.
If you wish to use the remote control bracket,
install screws from remote pack through bracket
and into the desired installation site as shown in
diagram 2
. The remote control transmitter rests
on the bracket.
page 7
7. Wiring.
diagram 1
diagram 2
white supply wire
black supply wire
black
black
white
blue
blue
white
from receiver
black
AC IN L
AC IN N
white
whit
e
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
ground (green
or bare)
black
Remote Control
Bracket
Wall
Bracket
Screws
