page 4
NOTE
:
See instructions above (Section 5) in order
to
temporarily
hang fan on hanging bracket
during wiring.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
wire from fan to
BLACK
wire
from ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire
from ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires from fan
together to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
Since this fan does not come with a light kit, you
will need to cap off the
BLUE
wire with a wire
connector (
as shown with arrow in diagram at right
).
[
Note
: If you elect to purchase a light kit for the fan,
the
BLUE
wire from the fan must be connected to
the
BLACK
wire from the ceiling instead.]
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
6. Wiring.
outlet box
hanging
bracket
motor
assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GREEN
GREEN
GROUND
(GREEN
OR BARE)
(supply circuit)
WHITE
BLACK
SWITCH
wire
connector
hanging
bracket
hanging
bracket slot
Remove 4 motor mounting screws and lock
washers from the bar on the top of motor
assembly; leave rubber cushions in place. Lift
motor assembly to hanging bracket and place
one end of motor assembly in hanging bracket
slot. This will allow motor assembly to hang out
of the way while wiring.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
motor assembly
motor
mounting
screws and
lock washer
5. Preparation for Wiring.
