page 7
11. Light Kit Assembly. (Optional)
WARNING:
Failure to disconnect power
supply at main panel prior to light kit assembly
may result in serious injury.
IF YOU WISH TO USE YOUR FAN WITH A LIGHT KIT
(sold separately)
, remove 3 screws from switch
housing and then remove switch housing cap from
switch housing. (Refer to
diagram a
.)
Locate
BLUE
(or
BLACK
) and
WHITE
wires in the
switch housing labeled FOR LIGHT. Remove and
discard plastic that holds these 2 wires together.
(Refer to
diagram a
.)
If your light kit is to be mounted directly to switch
housing, remove 3 screws from light kit fitter (refer
to
diagram b
). Make wire connections as described
below.
If your light kit is to be attached by a threaded rod
(refer to
diagram c
), remove the hex nut and lock
washer from the threaded rod on the light kit fitter.
Punch center cap out of switch housing cap with a
screwdriver. Push wires from light kit fitter through
hole in middle of switch housing cap and screw
switch housing cap onto threaded rod followed by
the lock washer and hex nut that were previously
removed. Tighten hex nut over lock washer for a
secure fit. Make wire connections as described below.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from switch housing. Connect
BLACK
wire from
light kit fitter to
BLUE
(or
BLACK
) wire from switch
housing.
Be sure molex connections snap together
securely.
Align holes in switch housing cap or light kit
fitter with holes in switch housing. Re-insert 3 screws
that were previously removed and securely tighten
all 3 screws.
Attach glass shade(s) to light kit fitter using the
hardware provided with the light kit. (Refer to
diagram d
.)
Note
: If you are installing a bowl fixture, the bulb(s)
must be installed
first
.
Install bulb(s) specified by the light kit. (Refer to
diagram d
.)
If you are installing a halogen bulb, be sure
not to handle glass directly with your fingers as oil from
the skin may shorten the life of the bulb.
Important
: When changing bulbs, remember to
allow bulb(s) and glass shade(s) to cool before
touching.
bulb
[
representative only
]
glass shade
[
representative only
]
light kit fitter
[
representative
]
diagram a
diagram b
diagram d
switch
housing
motor
housing
switch housing cap
switch housing cap
diagram c
hex nut
lock washer
light kit fitter
[
representative only
for using threaded rod
to attach light kit
]
switch housing cap
center cap
light kit fitter
[
representative only]
white wire
blue (or
black) wire
