page 3
3. Installation Preparation.
This fan can be mounted as a
flushmount
on a regular (no-slope) ceiling
only
.
Downrod
installations are
not
available for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
downrod
installation
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings
blade edge
7 feet
(2.13m)
(76cm)
30
inches
10f
t.
- 12f
t.
10ft. - 12ft.
(3.05m - 3.66m)
(3.05m - 3.66m)
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to
400 square feet (37.2 square meters).
4. Hanging Bracket Installation.
hanging
bracket
spring washers
ON
OFF
ON
OFF
rubber cushions
outlet box screws
flat washers
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is
turned to the OFF position.
WARNING:
Failure to disconnect power supply prior
to installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be
sure the outlet box is securely attached to the
building structure and can support the full weight of
the fan. Ensure outlet box is clearly marked "Suitable
for Fan Support." If not, it must be replaced with an
approved outlet box. Failure to do so can result in
serious injury.
CAUTION
:
Be sure outlet box is grounded properly
and that a ground wire (
GREEN or BARE
) is present.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box. * Install rubber
cushions between outlet box and hanging bracket
to reduce vibration of metal to metal surfaces. Pull
electrical wiring from outlet box through center
hole in the hanging bracket.
*Note
:
It is very important that you use the proper
hardware when installing the hanging bracket as
this will support the fan.
