page 7
8. Blade Assembly.
pull chain
extension
reverse switch
weatherproof
cover
9. Testing Your Fan.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may crack
and break.
Time Saver
: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and align
holes. Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are installed
with blade arm screws, discard plastic motor locks (
save
blade arm screws and lock washers to secure blade arms
).
Align blade arm holes with motor screw holes and
attach blade arm with lock washers and blade arm
screws. Before securing screws permanently, repeat
with remaining blade arms. Securely tighten all screws.
NOTE
: Tighten blade arm screws twice a year.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with pull chain.
(
diagram 1
) Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan
to LOW. Fourth pull will again set the fan to the OFF
setting. If fan does not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely LEFT
or
completely RIGHT
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
WARNING
: Do NOT remove weatherproof cover from
reverse switch.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the
pull chain.
diagram 1
blade arm screws
lock washers
blade attachment
screws and washers
motor housing
blade arm
blade
plastic
motor lock
diagram 2
diagram 3
diagram 4
