page 6
7. Wiring.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
Note
:
Excess lead wire length from the fan can be
cut to the desired length and then stripped.
DANGER
: If using this fan in a WET or DAMP
location, this fan must be connected to a supply
circuit that is protected by a Ground Fault Circuit
Interrupter (GFCI) to reduce the risk of personal
injury, electrical shock or death.
When downrod is secured in place on the
hanging bracket, electrical wiring can be made as
follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from fan to
WHITE
wire
from ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together
from fan to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect
BLUE
wire from fan
to the
BLACK
supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
8. Canopy Assembly.
canopy
hanging bracket
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
*
from ceiling
from fan
ground
(green or bare)
hanging bracket
This fan is remote control adaptable (remote
control sold separately).
Note
: Only remote
controls approved for WET locations can be used
with this fan.
wire connector
wire
connectors
Temporarily raise canopy to hanging bracket to
determine which 2 screws align with slotted holes in
canopy, and then lower canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set
aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws and secure all screws with Phillips
screwdriver.
