page 9
9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in center of fitter
plate with loosened screws in motor plate,
allowing molex connections from motor
housing to come through hole in middle of fitter
plate. Twist fitter plate to lock. Re-insert screw
that was previously removed and securely
tighten all 3 screws with a Phillips screwdriver.
[
Refer to
diagram 1
.
]
If you wish to use the light kit
, remove 1 screw
from underside of fitter plate and partially
loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from LED light kit. Connect
BLACK
wire from motor housing to
BLACK
wire from
LED light kit. Be sure molex connections snap
together securely. [
NOTE:
If you will NOT be
using the light kit, do NOT connect the molex
connections.]
Carefully arrange wiring within the back of
LED light kit. Align slotted holes in LED light kit
with loosened screws in fitter plate. Twist LED
light kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely. [
Refer to
diagram 2
.
]
Locate slots on glass shade and align with
nodules on inside of LED light kit.
Gently push
up on glass shade and turn
to the RIGHT
(clockwise)
until it slides completely into place.
[
Refer to
diagram 3
.
]
If you do NOT wish to use the light kit
,
locate
slots on metal cover and align with nodules on
inside of
LED light kit
. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
until it
slides completely into place.
[
Refer to
diagram 4
.
]
CAUTION
: D
o
not
connect the LED light kit if
you do NOT wish to use the light.
metal cover
glass shade
nodules
slots
LED light kit
LED light kit
motor plate
molex connections
molex connections
fitter plate
diagram 2
diagram 1
diagram 4
diagram 3
motor
housing
motor housing
nodules
slots
LED light kit
screw
