page 8
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Locate blade attachment screws/washers in
hardware pack. Hold blade arm up to blade
and align holes. Place blade plate on top of
blade, aligning posts in blade plate with holes
in blade as shown and insert 3 blade
attachment screws/washers, with fingers first
and then tighten screws securely with a
Phillips screwdriver. Repeat for the remaining
blades.
Locate 6 blade arm screws/lock washers in
one of the hardware packs. Align blade arm
holes with motor screw holes (
located on the
underside of the motor housing
) and attach
blade arm with blade arm screws/lock
washers. Before securing screws completely,
repeat procedure with remaining blade arms.
Secure all screws.
Note
: Tighten blade arm screws twice a year.
hanging
bracket
canopy
screw
screw
canopy cover
blade arm
motor screw holes
blade plate
blade attachment
screws/washers
blade arm screws/
lock washers
blade
