page 8
9. Blade Assembly.
motor housing
blade screw and washer
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Time Saver
: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
one of the hardware packs. Hold blade arm up to
blade and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first and
then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock washers
to secure blade arms
). Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat with remaining blade
arms. Securely tighten all screws.
NOTE
: Tighten blade arm screws twice a year.
plastic
motor
lock
blade arm
blade
blade attachment
screws and washers
lock washers
blade arm
screws
switch housing cap
light kit fitter
switch housing
center cap
motor housing
switch housing
cap
hex nut
lock washer
10. Light Kit Assembly.
Remove 3 screws from switch housing cap.
If you wish to use fan WITHOUT the light kit
,
align
holes in switch housing cap with holes in switch
housing. [
Note
: The gap on the top edge of the
switch housing cap must align with the reverse
switch on the switch housing for the proper fit.]
Secure switch housing cap with 3 screws that were
just removed.
Please proceed to Section 11 on the next page to
complete installation WITHOUT the light kit.
If you wish to use fan WITH the light kit
, locate
BLACK
(or
BLUE
) and
WHITE
wires in switch housing
labeled FOR LIGHT.
Remove hex nut and lock washer from threaded rod
at top of light kit fitter. Punch center cap out of switch
housing cap with a screwdriver. Feed wires from light
kit fitter through center hole in switch housing cap.
Then, screw switch housing cap onto threaded rod
followed by lock washer and hex nut. Tighten hex nut
over lock washer for a secure fit.
["Light Kit Assembly" continued on next page.]
white wire
black (or blue)
wire
