page 5
NOTE:
The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
5. Fan Assembly (with downrod).
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nut at top of motor
housing.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align
with holes in yoke--
make sure wires do not
get twisted
. Re-insert pin and clip that were
previously removed. Tighten yoke set screws
and nut securely.
[
Refer to
diagram 2
.
]
Slide canopy over downrod.
[
Refer to
diagram 3
.
]
Thread safety cable and wires through hanging
ball; then, slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on
hanging ball) completely could result in the
fan becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
diagram 1
set screw
hanging ball
stop pin
pin
clip
downrod
electrical wiring
yoke set screw
and nut
pin
clip
motor
housing
diagram 2
diagram 3
diagram 4
set screw hole
stop pin
canopy
hanging ball
downrod
electrical wiring
canopy
motor
housing
