page 9
fitter plate
dimmer
switch
wall control
wire
wire
wire
12V battery
10. Handheld Remote Control
Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the
wall control but do
not
wish to use the handheld
remote control, please proceed to Section 11.
Gently pull on remote control cover to separate top and
bottom parts.
[
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote control, cut
each wire on wall control (that was not previously used)--use
wire cutters to cut off each wire as close to the wall control
as possible.
[
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall control.
[
Refer to
diagram 2
.
]
The dimmer switch (labeled
ON
and
D
) has been pre-set to
the "ON" position (
ON
). If you do not wish to have dimming
capability, please move the switch to the "OFF" position (
D
).
[
Refer to
diagram 2
.
]
Align holes in wall control with posts located on
inside
of TOP
part of remote control cover and press together firmly. Place
wall control into BOTTOM part of remote control cover,
aligning posts in top of remote control cover with post holes
in the bottom.
[
Refer to
diagram 3
on the next page.
]
[”Handheld Remote Control Assembly" continued on
next page.]
(top)
(bottom)
remote control
cover
diagram 1
diagram 2
I
I I
IV
VI
I I I
V
9. Light Kit Assembly. (cont.)
Attach glass in shade by pressing down 4 tabs
on the inside edge of the shade down to secure
the glass.
Remove 4 screws from outer edge of fitter plate
using the Allen wrench (included). Align holes in
fitter plate with holes on glass shade. Re-insert
screws that were just removed and securely
tighten all 4 screws with the Allen wrench.
glass shade
motor housing
Allen wrench
Allen wrench
