Craftex CT200, Руководство пользователя

Страница: 12 / 30

ASSEMBLY
Installing Tilt Knob and Fence
Lock Handle
llows you to lock
stalling the Cutter-Head Guard
The tilt lever is used to tilt the fence up
and down to your desired angle.
The fence lock handle a
the fence in that angle so that the fence
does not move while cutting operation.
Once you have installed the fence to the
carriage, take the fence lock handle and
install it to the fence carriage and attach
the tilt lever to the threaded hole on the
fence. (See figure 7)
Figure 7: Installing fence lock handle and
tilt knob
In
ve enough
pace. Now insert the cutter-head guard
haft and use the set screws to tight it.
Figure 8: Installing cutter-head guard
rd over the cutter-head.
To install the cutter-head guard move the
fence backward so that you ha
s
s
(See Figure 8)
The guard is provided with spring so that
when it gets pulled backward, it spring
back forwa
After you are done installing the guard,
test the guard by pulling it backward. If
the guard does not spring back over the
cutter-head, it means that the guard is
not installed properly. Re-install it
following the directions above.
The cutter-head guard is a very
important safety feature of this
machine and must be installed properly
to avoid possible injuries.
12