Craftex CT200, Руководство пользователя

Страница: 17 / 30

Inspecting the Cutter-Heads
er than the others, you will
tter-head guard so that you
an have access to the cutter-head.
N
th r
the cutter-head. Rotate the cutter head
body and check the height of each
carbide insert with the out-feed table.
The inserts
t touch the bottom
of the straight edge. If the inserts are set
too high or too low then they should be
adjusted.
Adjusting /Replacing the Carbide
The cutter-heads are supposed to be at
the same height with each other and with
the out-feed table. If one of the carbide
inserts is high
get a poor result while doing any cutting
operation.
To inspect the cutter-heads disconnect
the jointer from the power source and
remove the cu
c
ow, take a straight edge and put it on
e out-feed table so that it hangs ove
should jus
Inserts
The carbide inserts get dull after
sometimes and need to be adjusted or
replaced occasionally.
To adjust or replace the carbide inserts,
disconnect the machine from the power
source and remove the cutter head guard
to expose the cutter head with the
carbide inserts.
ow, take a hex key and loosen the
crews on the carbide inserts that hold
ach carbide insert to the cutter head
ody. See figure 16
nd thus it has four cutting edges
s dull,
imply rotate it 90 degrees and you will
et a new and fresh cutting edge. When
ll four edges of the carbide insert are
sed replace it with a new one.
Figure 17: Rotating carbide insert 90°
N
s
e
b
Figure 16: Removing the carbide inserts
Clean all the dust and debris on the
cutter-head body and on the insert and
replace it with a new one.
The carbide insert has a square shape
a
. When
one edge of the carbide insert get
s
g
a
u
IMPORTANT: Remember if the dust
and debris on the cutter-head body is
not cleaned, it will make the insert out
of height alignment and may result in
poor cutting performance.
OPERATIONS AND ADJUSTMENTS
17