Craftex CT174, Руководство пользователя

Страница: 10 / 20

10
INSTALLING THE DUST
PORTS
Install the dust ports to the back of the
sanding belt frame and the sanding disc
cover using the pre-installed screws and
washers. See figure-7 and figure-8.
Figure-7 Installing sanding belt dust port
Figure-8 Installing sanding disc dust port
INSTALLING THE TABLE
The table is most commonly installed to be
used with the sanding disc but it can also
be installed to be used with the sanding belt
when the sanding belt is in vertical position.
Loosen the two set screws at shown in
figure-9 and slide the table support rod into
the hole, making sure that the flat surface of
the rod is facing the two set screws. Then
tighten the two set screws. See figure-9.
Figure-9 Installing the table support rod
Slide the table support on to the support rod
as shown in figure-10 & figure-11 making
sure that the flat surface of the rod is facing
the set screws on the table arm, and then
tighten the set screws.
Figure-10 Table to be used with the
sanding disc
Figure-11 Table to be used with the
sanding belt