Craftex CT174, Руководство пользователя

Страница: 8 / 20

8
INSTALLING THE
SANDING DISC
The CT174 comes with a 9” PSA (pressure
sensitive adhesive backed disc). To install
the disc follow the instructions below.
Remove the lock knob and open the
sanding disc cover shown in figure-2.
Figure-2 Opening the sanding disc cover
Clean the plate before installing the sanding
disc and make sure there is no dust or
debris on its surface. You may experience
poor and unsatisfactory results, or the
sanding disc may loose contact with the
plate during operation if there is dust or
debris on the plate surface.
Peel the paper at the back of the sanding
disc and install the sanding disc on to the
plate. Make sure the sanding disc is
centered and adheres completely flat
against the plate. See figure-3.
Figure-3 Installing the sanding disc
INSTALLING THE
SANDING BELT
The CT174 comes with a 6” x 48” sanding
belt. To install the sanding belt:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Remove the belt safety guard (if already
installed) by removing the four lock knobs
shown in figure-4.
Figure-4 Removing the belt safety guard
WARNING
Make sure the switch is in the OFF
position and the cord is disconnected
from the power source when
installing/removing parts, adjusting and
servicing the machine. Failure to do so
may result in serious personal injuries.