Craftex CT174, Руководство пользователя

Страница: 11 / 20

11
INSTALLING THE BACK
STOP
When the sanding belt is set for horizontal
sanding, the backstop should be used to
prevent the work piece flying out while
sanding.
Install the backstop to the sanding platen as
shown in figure-12 using screw and washer
provided.
Figure-12 Installing the backstop
ON/OFF SWITCH
CT174 is equipped with a rocker-type
power switch which starts and stops the
motor and is located on sanding disc side
on the base of the sander.
The switch features a removable locking
key to prevent unauthorized operations.
When the sander is not in use for a long
period of time, simply remove the locking
key and store it in a safe place.
To start the sander, insert the locking key
and shift the switch to the right.
Figure-13 ON/OFF switch
IMPORTANT
Make sure to remove the backstop when
using the work table with the sanding
belt in vertical position.
IMPORTANT
To prevent any type of accidental
injuries, make sure the power switch is in
the OFF position before connecting the
sander to the power source.