Craftex CT172, Руководство пользователя

Страница: 12 / 15

12
FACEPLATE
This lathe is furnished with a face plate in
case the work-piece to be turned and can
not be clamped between the headstock
center and the tailstock center.
The faceplate has been drilled with eight
holes for clamping the work-piece.
Figure-13 Faceplate
MAINTENANCE
During the life of your machine, you will need
to practice some regular maintenance to
keep your lathe in peak performance
condition.
1. Check the lathe daily for:
A. Loose mounting bolts
B. Worn or damaged wires
C. Worn switch
D. Any other unsafe condition
2. Protect the unpainted cast iron surfaces of
the lathe by clean the chips after every
use and wiping with dry piece of cloth.
3. Apply a thin layer of oil on the bed slide
ways and the unpainted cast iron surface
to keep the bed rust-free.
4. A build up of dust in the motor can cause
motor damage. Periodic cleaning of the
motor is not only recommended, but
mandatory for normal wood lathe
performance.
WARNING
Make sure the switch is in the OFF
position and the cord is disconnected
from the power source before installing,
servicing and removing/replacing any
components on the machine. Failure to
do so may result serious personal
injuries.