Craftex CT172, Руководство пользователя

Страница: 10 / 15

10
TEST RUN
Once you have assembled your lathe
completely, it is then time for a test run to
make sure that the lathe works properly and
is ready for operation.
During the test run if there is any unusual
noise coming from the lathe or it
excessively, turn OFF the power switch
immediately and disconnect from the power
source Investigate if you can find out the
problem with your machine.
Make sure the ON/OFF switch and the
variable speed knob, located on the left
side of the lathe, are working properly.
ON/OFF SWITCH
The ON/OFF switch on this mini lathe is
located on the left side of the machine,
attached to the bed.
The switch has a removable locking key to
prevent unauthorized operation. If the lathe
is not in use for long time, remove the
locking key by pulling it put out and store it
in a safe place. See figure-8.
Figure-8 Locking key
To start the lathe, insert the locking key and
shift the switch up. To stop the lathe, shift
the switch down. See Figure-10
VARIABLE SPEED KNOB
CT172 is a variable speed lathe. You can
always increase or decrease the spindle
speed while the machine is running, using
the variable speed knob shown in figure-9.
Figure-9 Variable speed knob
WARNING
Before starting the lathe, make sure that
you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
WARNING
Do not make any adjustments while the
machine is running. Failure to follow this
warning can cause serious personal
injuries to the operator and damage to
the machine.