Craftex CT073, Руководство пользователя

Страница: 12 / 30

12
CT073 10” LEFT TILTING ARBOR SAW
ASSEMBLY, CONTINUED
Rip Fence Assembly, Continued
‰
Use the combination square
and set the tail to 12mm. Use
this along the back surface so
that the rear rail sits 12 mm
below the table surface.
‰
Tighten all the screws.
‰
Attach the guide rail to the front
rail with the six 6mm screws and lock washers.
Rip Fence Adjustments
To adjust the rip fence so that it is
flush with the table saw surface, rotate
one or both of the nylon screws to
raise or lower the fence.
The edge surfaces of the rip fence
must be perpendicular to the table
surface. Use a combination square for
verification and adjust the nylon
screws as required.
To adjust the fence so that it is parallel to mitre slots, remove the fence and
adjust one or both of the setscrews in the ‘T’.
To adjust the clamping pressure of the cam lock, unlock the lever and remove
the fence from the guide rail. Adjust the two 4mm Allen screws until the fence is
held securely when the cam lever is depressed.
NOTE: This has been adjusted at the factory and should not require any
further adjusting.