Revised: March-11-16
4
6.
Install the Bottom Guide -
Part: G
ü
Clean the bottom surface using a degreaser or alcohol based cleaner
ü
Align the bottom guide with the anchor plates, jamb profile and top track
ü
Temporarily position the bottom guide to ensure proper fitment, the bottom guide should fit under the
magnet located in the jamb profile
ü
Note: Do not place the bottom guide underneath the jamb profile
ü
Note: The bottom guide may require additional cutting to fit the application
ü
Note: When connecting two lengths of the bottom guide connect the ends marked with a red line
ü
Once the bottom guide has been positioned, peel the backing off of the guide and press down on the bottom
guide to ensure a secure bond
ü
Note: The bottom guide may not fully adhere in cold weather applications. It is recommended that the
bottom guide adhesive is at room temperature before installation and that the bottom surface is clean and
dry. In addition, the bottom guide can always be fastened to the bottom surface with a countersunk, flat
head screw.
7.
Install the Screen Cartridge -
Part: E
ü
Cut a piece of plywood or similar wood product to the following dimensions: 1-3/4” (45mm) wide x 6”
(152mm) long
ü
Use the piece of wood to spread the top track, while inserting the pull-bar retainer into the top track
ü
Line up the pull-bar retainer besides the wooden spreader and insert the top of the screen cartridge into the
top track
ü
Note: be carefully not to bend the steel band when inserting the screen cartridge into the top track
ü
Remove the wood spreader from the top track
ü
Align the bottom of the screen cartridge with the bottom guide
ü
Snap the ST base jamb profile into the “base-jamb mount ” by applying moderate horizontal force to the
screen cartridge
8.
Install Handles -
Parts: H and I
ü
Find the knob on the rear of the handle
ü
Insert the knob into the groove in the pull-bar (
Part: C
) at 90 degrees
ü
Adjust the handle to your desired height and turn the handle counter-clockwise until it snaps into place
9.
Adjust the Jamb Lock -
*Optional - Part: L
ü
Extend your screen system so that the pull-bar engages the jamb lock. If the jamb lock does not fully engage,
please perform the following steps:
ü
Retract your screen system
ü
Pull the handle on the jamb lock upwards, while holding the base of the jamb lock in place
ü
Use a #1 Phillips screwdriver to turn the mounting screw 1/2 turn, counter-clockwise
ü
Adjust the jamb lock up and down so that the jamb lock fully engages the pull-bar in the locked position.
ü
After the height has been adjusted, tighten the mounting screw on the jamb lock
10.
After installing your screen system, repetitively extend and retract the screen to ensure a smooth operation. If
you experience any one of the following problems, please refer to the trouble-shooting guide:
ü
The pull-bar does not completely close to the jamb
ü
The screen does not completely retract
ü
The screen does not operate smoothly
