Crafco 30 Dust Control Router, Инструкция по эксплуатации и запасным частям

Страница: 52 / 98

Model 30 Pavement Router Manual
Maintenance Instructions Chapter 6
©2018 by Crafco, Inc. All Rights Reserved………………..………………………………..….…How to Use a Multimeter 6-12
6.9 V-Belts
Check and tighten the V-belts as required after 2 hours of operation. To tighten V-belts, adjust jam
nuts under engine mount. (
Figure 6.6 ). The V-belts should be changed once they can no longer be
tightened to the correct tension, or when showing signs of excessive wear. Follow the steps in
Table 6-7 to change the V-Belts. Recheck belt tension after 8 hours and every 40 hours thereafter.
Always replace both belts and inspect sheaves for wear.
CAUTION
Do not over-tighten belts as damage will occur to belts and bearings. Belts that are too loose will
shorten the life of the belts and sheaves. When installing new belts do not attempt to stretch over
sheaves.
Step Action
1 Remove belt guard by removing 4 bolts. ( Figure 6.7 ).
2 Loosen belt tensioner until bottomed out. ( Figure 6.6 ).
3 Remove old belts. Install new belts.
4
Tighten belt tensioner. Correct tension is 1/4” deflection per belt when 10 lbs. pressure is
applied. Incorrect belt tension will cause poor belt life, damage to bearings, and engine
crankshaft bearing failure.
5 Install belt guard.
Table 6-7 Changing V-Belts