Model 30 Pavement Router Manual
Operating Instructions
Chapter 5
©2018 by Crafco, Inc. All Rights Reserved……………..…………………..……………………..….Operating Instructions 5-6
5.7 Attaching Cutter Head Dust Shroud
For Model 30 Pavement Dust Control Router, follow these procedures to attach all dust control
mechanisms before starting or operating the machine.
Step
Action
1
To make attaching the cutter head dust shroud more accessible, raise the front of the
router. To raise the front of the router, push down on the handle bars until the router is
resting on the handle and the corner of the frame assembly. See
2
Remove cutter head dust shroud from the storage bracket and bring around to front of
router.
3
Bring the shroud up from the bottom of the housing and align the pin hole with the slots in
the mounting brackets.
4
Install the pin and secure with washer and 5/16” x 3/8” hairpin.
5
Use the Brush Manipulation Tool to push the Seal Brushes on both sides of shroud up
above the cutter housing. The brushes should be in an upward position. See
6
Lower the router back onto its wheels.
7
Make sure the large particle dust collection bin is empty and is securely attached to
mounting bracket before beginning your routing operation.
8
Make sure the dust collection bag is clean and securely clamped to filter mounting bracket
with adjustable quick release gear clamp. The quick release gear clamp is adjustable and
should be adjusted so that it holds the dust collection bag securely in place. Do not over-
tighten the clamp as this may damage the dust collection bag. The support rod was
designed so it could be slid into a rearward position for transportation of router where
space is limited. The support rod should be fully extended in its forward position before
routing begins.
9
Raise the cutter mechanism by pushing the rocker switch to the up position.
10
Open fuel valve on bottom of fuel tank.
Table 5-5 Attaching Cutter Head and Dust Shroud
