CPC Router and Repeater, Инструкция по установке и эксплуатации

Страница: 17 / 24

% & '
•
#
-
4.1 The Router
The router (P/N 572-4200) must be placed in one of
the two correct positions pictured in Figure 4-1
.
As shown in Figure 4-2 the base plate is to be installed
in an electrical box either vertically (base plate interior
arrows pointing up) or rotated clockwise 90° (base plate
interior arrows pointing to the right). These two orienta-
tions provide optimal viewing of the front panel legends of
an installed router module, and also accommodate differ-
ent methods of installing electrical boxes.
When the wiring and installation of the router base
plate are complete, the router module may be installed.
The router module is installed by aligning the unit to the
base plate and gently pushing the module onto the base
plate. It is not necessary to power down the system to
install the router module; it can be plugged in while the
system is running.
4.2 The Repeater
The external repeater (832-1010) is externally
mounted within its own enclosure. The internal repeater
(P/N 832-1000) is mounted inside of the Einstein control-
ler panel.
For external repeaters, the mounting bracket at the bot-
tom of the enclosure has two 0.156” bolt holes on either
side. Use the bolt holes to mount these repeaters in the
field as necessary (see Figure 4-3).
When mounting external repeaters, keep in mind that
they require a 24VAC Class 2 power source in order to
operate. This will likely require a transformer such as P/N
640-0041 (110V) or P/N 640-0042 (220V) to be mounted
near the external repeater enclosure. Make sure there will
be enough space next to the repeater to mount the trans-
former.
Figure 4-1
- Router Base Plate Orientation
Figure 4-2
- Router Mounting
Figure 4-3
- External Repeater Mounting