14/15
Use and Care Manual
Automatic Timer
•
Approx. 15 minutes later from turning on the chair, all operations including Heating and
Heating or Relax/Stretch function will stop, and keep the reclined position it have reached,
along with all the lamps except the ON/OFF extinguishing. The chair become in idle mode,
until you press any function buttons.
7.Heating:
Press the button to start heating located on both side of lumbar , with the button lamp on.
Press the button again to stop the heating, with the button lamp off.
•
After heating is activated, when you change the angle of back rest or leg rest, the heating will
be paused, and resume automatically until the chair angle motion is finished.
8. Home:
Press the button to make chair restore in right position.
•
After Heating or Relax/Stretch function is activated, when you change the angle of back rest or leg
rest, the Heating or Relax/Stretch function will be paused, but resume automatically when the
back rest or leg rest angle motion is finished.
Home
CAUTONS AFTER USE
•
Bring all parts of the chair to their home position.
•
Turn off the power.
•
When the equipment will botbe used for an extended period, be sure to disconnect the
power plug from the outlet.
Head rest, back pad, seat cover, arm rest, foot rest, pillow(leather)
Perform daily maintenance by wiping with a soft dry cloth. When parts are badly soiled, adopt
the following maintenance procedure.
1) Soak a soft cloth in diluted neutral kitchen detergent and squeeze it well. Wipe the main unit
with the damp cloth in a tapping motion.
2) Soak a cloth in clean water, and squeeze it well. Wipe off the remaining detergent with the
damp cloth.
3) Wipe it with a dry cloth afterwards.
•
Do not force-dry with a drier.
•
Do not force contact with vinyl products for an extended period. It may cause discoloration.
MAIN UNIT ( Wooden chair foot , frame and the control panel)
•
Impossible to recline. Impossible to raise or lower the foot rest. Remove the obstruc tion.
Check that there is no obstruction. This phenomenon is caused by the timer, but not a problem.
The chair stops in the middle of operation. Operation failure Well con nect the DC terminals
between the chair and power adaptor. Check that the power adaptor is well connected to the
chair. Push the power plug into the outlet securely. Check that the power plug is securely
plugged into the outlet. Countermeasures Check points Type of Troubles Wipe with a soft dry
cloth. Do not wipe with a damp cloth.
MAINTENANCE PROCEDURE
WARNING
•
Be sure to disconnect the power plug from the outlet prior to maintenance.
•
Do not attempt to use benzene, thinners, alcohol, alkaline detergent or a bleaching agent for
cleaning as this may lead to discoloration or cracking;
NOTE
•
Leather is a natural material, so imperfections grain, dye variations and natural
markings do not constitute a defect.
•
Polyurethane foam padding tends to soften and light creases may form on the leather cover
over a period of three months. These are natural occurrences and do not require any type of
maintenance.
•
A professional cleaner should be contacted for particulartypes of stains such as ink marks.
NOTE
