1018454-D
Page 11
INSTALLATION
A
B
Install on the right
side
OR
left side of
the housing.
A
B
C
C
30
30
STEP
10.
- Remove the door from the heater housing.
- Locate the Pilot Pro in the carton and remove the cover from
baseplate with a screwdriver.
- The Pilot Pro may be installed near the base of either side of the
heater housing.
When selecting a side for installation, be sure to
allow room for future removal of the pilot pro cover.
-
Check the inside of the housing for safety labels. Try to avoid drilling
through any pertinent safety information during this step.
USE THE MOUNTING PLATE (30) FOR THE
FOLLOWING STEPS. MOUNTING PLATE MUST BE
MOUNTED AS DIRECTED BELOW OR WIRE HARNESS
WILL NOT REACH.
1. PLEASE NOTE
A
OF THIS STEP.
Do not mount the PilotPro any higher than the top of the
access door of the housing.
2. PLEASE NOTE
B
OF THIS STEP.
Align the PilotPro very close to the back edge of the housing.
3. PLEASE NOTE
C
OF THIS STEP.
Be sure to face the notch / cutout of the mounting plate (
30
)
toward the wall.
4.
Using the mounting plate (
30
) as a template, align in place as
illustrated. Using a marker or pencil, leave a mark for the three
hole locations on the metal housing.
SET ASIDE THE MOUNTING PLATE (30)
.
5.
Drill the three holes into housing using a 3/16” drill bit.
DO NOT DRILL DIRECTLY THROUGH MOUNTING PLATE.
DRILL MAY CRACK THE MOUNTING PLATE.
W
ALL
W
ALL
Left
Side of
Heater
W
ALL
W
ALL
Right
Side of
Heater
