COX CXO300, Руководство по установке

Страница: 28 / 60

28 CXO300 INSTALLATION MANUAL
6.0 STEERING
6.0
STEERING
6.3.7
The Dometic ECU supplies power to Cox private CAN network.
6.3.8
Make sure that only equipment supplied or approved by Cox is connected to the CAN
network. Connections which are made with equipment that is(are) not approved by Cox are not
validated system(s).
6.4.0
For three or four outboard installation, the center outboard(s) are controlled through a tie bar.
On three installed outboards, the tie bar links the center outboard to the starboard outboard.
Refer to Dometic tie bar instructions for installation.
STEERING CYLINDER SPACER KIT INSTALLATION - SK000100
Installation of the Dometic EPS tournament steering cylinder to the CXO300 PTT requires the use of SK-
000100 steering cylinder spacer kit.
Use the following guide to ensure the correct spacer thickness is installed and record the results
6.5.1
Measure Distance ‘A’ - Welded nut, then choose spacer from table. Record the measurements
in table 6.5.5
Figure 6.5a. Steering actuator install guide - welded end spacers
CAUTION
Make sure that you do not connect 3rd party electronics into the Cox private CAN network.
CXO300 Outboard Steering Actuator Install Guide - Step 1: Welded end spacers selection
What is measured length A?
A ≤ 5,5 5,5 < A ≤5,75 5,75 < A ≤ 6 6 < A ≤6,25 6,25 < A ≤6,5
Selected Spacer Thickness (mm)
036555
(thickness marked on spacers)
T = 5,75 T = 6,00 T = 6,25 T = 6,50 T = 6,75
CAUTION
Make sure that you do not connect the Cox private CAN network to another power supply.