COX CXO300, Руководство по установке

Страница: 14 / 60

14 CXO300 INSTALLATION MANUAL
4.0 MOUNTING THE OUTBOARD
4.0
MOUNTING THE OUTBOARD ONTO THE TRANSOM
4.11.0
Make sure that you use a 6 mm pilot drill to make initial holes in the transom. Make sure that
the drill is always at 90 degrees to the transom when drilling the holes.
4.12.0
Make sure that you use a clearance drill to finish the holes for the 12 mm bolts (M12).
4.13.0
Make sure that you use the correct specification bolts, nuts and washers (M12 x 1.75mm
Stainless Steel grade A4-80) to attach the outboard to the transom.
4.13.1
Make sure that the length of the bolts are long enough to go through the PTT, transom , the
lock nut and all washers.
4.13.2
Make sure two full threads of the bolts are showing through the nyloc nuts.
4.14.0
Make sure that you apply marine sealant (Sikaflex 291i or equivalent) to the areas around the
mounting holes on the PTT and to transom face.
4.15.0
Make sure that you use a gantry crane (A-frame) to move the outboard into position and mount
to transom.
4.16.0
Make sure that you apply marine sealant (sikaflex 291i or equivalent) to the bolts. Torque the
fasteners to 80 Nm.
B B
A
A
C C
D
E
H
F
G
Figure 4.10
Engineering
drawing showing
the PTT-Transom
layout - mm (in).
A 13 (0.51)
B 163.5 (6.44)
C 125.4 (4.94)
D 95.2 (3.75)
E 318.5 (12.54)
F 92.5 (3.64)
G 115.3 (4.54)
H 18.5 (0.73)