Version 1.0b
7
INSTALLATION, STEP 1
Step 1 assumes that all electrical systems, up to and including the Inglenook electrical box holding the
duplex outlet are installed. This standard 15-ampere electrical outlet is located on the lower right side wall
behind the bottom grill. Previous pages of this manual cover installation of the electrical system or refer to
the Inglenook fireplace Owners Manual for additional information.
Fully open the lower air inlet grill of the Inglenook. It is not necessary to remove the lower grill; however,
it is necessary to protect the grill from damage during the installation of the blower system.
FIGURE 3 shows the blower electrical harness. This wiring harness comes pre-manufactured from the
factory. This harness requires no special tools to install. Before installing the blower unit into the
Inglenook fireplace, assemble the harness, including the thermo snap disk. The blower system can now be
tested before installation by plugging it into any wall outlet and heating the snap disk with a hair dryer.
WARNING:
Testing of the blower system requires electrical knowledge that cannot be provided in this
instruction manual. There are moving parts and dangerous electrical voltages present in the blower system.
If the blower is to be tested, the power cord should only be plugged in by a qualified electrician.
INSTALLATION, STEP 2
FIGURE 4 shows how to install the blower unit into the body of the Inglenook Fireplace. The wiring
harness IS NOT shown in FIGURE 4 for clarity purposes. Slide the blower alongside the Inglenook Ash
Pan Housing towards the back of the Inglenook. Position the blower unit between the Inglenook’s frame
supports as shown in FIGURE 4. The blower unit has magnetic feet that will hold the unit in place. NOTE:
If the blower rattles during operation, it is because the blower is not sitting flat on the floor or is touching
the back wall. Adjust the unit to eliminate rattling or provide some cushion between the wall and unit to
eliminate noise vibration.
FIGURE 4: BLOWER INSTALLATION
INSTALLATION, STEP 3
Once the blower unit has been positioned at the back of the Inglenook fireplace as shown in FIGURE 4, the
snap disk can be mounted in its holder. NOTE: 2 sets of two screws each have been provided for mounting
the snap disk into its holder. Only one set of screws is required. Depending on the snap disk mount, either
the 10-32 screws or the 12-24 screws will be required. FIGURE 4 shows the mounting location along the
