Cleaning
Page 12
Operation & Maintenance Manual - Vision Chilled Displays
2.7- AUTOMATIC EVAPORATING TRAY
•
Isolate the display from the electrical supply and then allow the drip-tray to cool down for 30 mins or so before touch-
ing.
•
The drip tray is located under the right hand end of the display when viewed from the rear. It can be accessed for clean-
ing by either removing a grille in the rear panelling of the counter or by removing the panel itself.
•
The exact method of access will depend on the counter construction. If you cannot work out how to get access you
must contact your installer.
•
The drip tray is a stainless steel tank about 500mm long and 100mm high, resting in it is a heating element, which is
connected via a short lead to a plug. Remove the plug from its socket and carefully lift out the drip tray and element
together. There is likely to be some water in the tray, which you should discard.
•
Inside the tray and on the element will be a build up of deposits similar to the scale inside a kettle. As much of this as
possible must be removed by a combination of scraping, Scotchbrite and kettle cleaner.
•
It is not necessary to achieve perfection, just remove the majority of the scale.
Be careful not to distort the element or to put any strain on the wiring when cleaning it
. Re-assembly is the reverse of
the above.
ONCE THE REAR ACCESS PANEL HAS BEEN
REMOVED YOU WILL SEE THE FOLLOWING
CAREFULLY UNPLUG THE EVAP TRAY AND
REMOVE FROM THE UNIT
CLEAN AND REPLACE
OPEN ACCESS REAR PANEL
EVAP TRAY
A
B
C
