Page 5
ASSEMBLY
.......................................................
—
The heater is packaged with the feet unattached. You must attach them before operating
the heater.
CAUTION:
Do not operate this heater
without casters attached.
WARNING:
Do not operate without feet
attached. Do operate the heater only in
upright position (feet on the bottom,
controls on the top), any other position
could create a hazardous situation.
Assembly Instructions:
Unpack the heater and remove all parts from the packaging.
For ease of assembly, place the heater upside down or on its side on a soft surface which will
not scratch the unit. Use one hand to hold it in place.
• Place the bowlegged castor-mounting plate in the front and put straight castor-mounting plate .in the
end.
1. Unscrew nut and washer and nut. (Fig B-1)
2. Attached casters with two metal plates with washer and nut (Fig B-2)
3. Place the bowlegged metal plate and wheel assembly between the last two fins at each end of the
heater as shown in Fig B-3,4,5.
4 .Attach the plate and wheel assemblies onto the heater with the U bolts and wiring nuts supplied as
shown in Fig B-3,4,5
5. Remove the wing nut from the U bolt and insert the U bolt through the holes in the plate and wheel
assembly as shown, reattach the wing nut and tighten firmly.(Fig B-6).Repeat this procedure on the
opposite side.
Location of the Heater:
1. Turn the heater upright. Ensure legs are correctly installed and level.
2. Place heater on a flat and stable surface. Setting the heater on an incline or decline may cause
damage to the unit and create a hazardous situation.
