COSMOGAS AGUAstore 1000, Инструкция по установке, использованию и техническому обслуживанию

Страница: 14 / 32

14
5 - INSTALLATION
Figure 5-1 - Connection between hot water heater AGUADENS 16 or 22 and AGUAstore storage tank.
5.1 - Examples of installation
WARNING! This storage tank must be used with a COSMOGAS hot water heater for the production of
DHW. Before proceeding with installation, the hot water heater’s installation, use and maintenance manual must
be read carefully.
Some examples of hydraulic connection diagrams are shown below:
Example of connection between hot water heater model AGUADENS 16 or 22 and AGUAstore storage tank (See fig. 5-1).
KEY to figure 5-1
1 - COSMOGAS hot water heater;
2 - Recirculation pump (responsibility of installer);
3 - Hot water heater hot water outlet;
4 - Gas inlet;
5 - Hot water heater cold water inlet;
6 - AGUAstore storage tank model;
7 - ----------;
8 - Storage tank sensor for hot water heater;
9 - DHW uses;
10 - ----------;
11 - Domestic cold water inlet:
12 - ----------;
13 - ----------;
14 - ----------;
15 - ----------;
16 - ----------;
17 - ----------;
18 - ----------;
19 - ----------;
20 - Expansion tank (provision the responsibility of the installer);
21 - ----------;
22 - Remote control (on request);
23 - Solar control unit (on request);
24 - S2 bottom storage tank sensor (from solar control unit);
25 - Solar safety and charge group (on request);
26 - Solar panels (on request);
27 - ----------;
28 - ----------;
29 - ----------;
30 - ----------;
31 - Storage tank safety valve;
32 - Isolation valve;
33 - Valve to adjust flow rate (responsibility of installer);
34 - Anti-limescale water softener (responsibility of installer);
35 - Check valve (responsibility of installer);
36 - Cold water usage;
37 - Impurity filter (responsibility of installer);
38 - Pressure reducer (responsibility of installer);
39 - S1 solar panel sensor (from solar control unit);
40 - S3 top storage tank sensor (from solar control unit);
41 - Thermostatic mixer (responsibility of installer);
42 - Drain (responsibility of installer);
43 - Solar expansion tank (responsibility of installer);
44 - Electronic anode;
NB EXAMPLES OF INSTALLATION - In this storage tank, the hot water heater is piggy-backed onto the
storage tank and can be equipped with a hydraulic connection kit and solar assembly mounted on the
hot water heater’s support bracket. In this case the positions of the solar control unit, solar assembly
and hot water heater will be on the storage tank itself.