16
17
Attach the microwave oven to the top cabinet.
Cabinet Front
Cabinet Bottom Shelf
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall
and the top cabinet.)
Filler Block
Microwave Oven Top
Equivalent to
Depth
of Cabinet
Recess
Insert 2 self-aligning screws
through outer top cabinet holes.
Turn two full turns on each screw.
ADJUST THE EXHAUST
ADAPTOR
Open the top cabinet and adjust the exhaust adapter
to connect to the house duct.
For Front-to-Back or Side-
to-Side Adjustment, Slide
the Exhaust Adapter as
Needed
Back of
Blower Plate
Damper
Microwave
Self-Aligning Screw
5
A5.
CONNECTING DUCTWORK
1
2
A7.
House Duct
MOUNT THE MICROWAVE
(cont.)
A6.
Install grease filters. See the Use & Care
Guide packed with the microwave.
8
Extend the house duct down to connect to the
exhaust adapter.
Seal exhaust duct joints using furnace duct tape
for high temperature applications
B
OUTSIDE BACK EXHAUST
(Horizontal Duct)
INSTALLATION OVERVIEW
B1.
Prepare Rear Wall
B2.
Remove Blower Plate
B3.
Attach Mounting Plate to Wall
B4.
Prepare Top Cabinet
B5.
Adjust Blower
B6.
Mount the Microwave Oven
IMPORTANT NOTES
• Make sure the screws for the
blower motor and blower plate
are securely tightened when they
are reinstalled. This will help pre-
vent excessive vibration.
•Make sure the motor wiring has
been properly routed and se-
cured and that the wires are not
pinched.
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall
for outside exhaust.
REMOVE BLOWER PLATE
Remove and save the screw that holds the blower
plate to the microwave. Lift off the blower plate.
Read the instructions on the REAR WALL TEMPLATE.
Tape it to the rear wall.
Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
4
7
