CEB-V850ES/FJ3·SJ3 Evaluation Board HardwareUser’s Manual
17
(2)RESET signal setting (JP7)
A setup of a RESET signal changes with apparatus connected.
JP7 performs a setup.
JP7
Function
1-2 short circuit
Normal use, During connecting FL-PR4, FL-PR5, MINICUBE (Default )
2-3 short circuit
During connecting MINICUBE2
Table 3.3.7 (2)
In case FL-PR4 or FL-PR5 or MINICUBE are used, a JP7 short pin is set to the "1-2" side, and it is set as
the course of dashed-and-dotted line (FL-PR4) and a dotted line (MINICUBE) among Figure 3.3.7(1).
(Refer to reset signal block diagram)
In case MINICUBE2 is used, a JP7 short pin is set to the "2-3" side, and it is set as the course of a solid
line (MINICUBE2) among Figure 3.3.7(1).
Please use a JP7 short pin for the "1-2" side at the time of real operation, setting it up (when you do not use
a debugger).
(3)RESET SW (SW4)
If SW4 is pushed, CPU and an evaluation board will be in a reset state.
3.3.8 INTP0 SW (SW2)
SW2 on a board is connected to P03-/INTP0 port.
A push on SW2 inputs "0" into P03-/INTP0 port.
3.3.9 NMI SW (SW3)
SW3 on a board is connected to P02-/NMI port.
A push on SW3 inputs "0" into P02-NMI port.
JP7
1
2
3
