Cosen C-320NC, Инструкция по эксплуатации

Страница: 49 / 166

4-13
Cutting status display & setup
When cutting is in operation, press to enter cutting status display and setup page.
Page 1 – cutting status display

This page shows the following information (from
top to bottom):

Feeding length (current feeding vise
position)

Blade speed

Deviation value (optional)

Current in ampere (optional)

Number of current cutting job/step in
operation

Preset quantity of current cutting job

Number of cuts finished

The green square light on the bottom left
corner indicates the warranty status of the
HMI touch screen. Warranty is one year and
starts counting after 70 hours of operation
after the machine is shipped. Warranty
status light turning to red indicates the HMI
touch screen has expired.

Error messages (highlighted in yellow; can
be cleared by pressing down for one second)

Press Home to return to the main control menu.

Press Next to go to the next setup page.
(Display without optional blade deviation detector included)
Page 2 – cutting status setup

This page comes in two versions depending on if the
optional blade deviation detector is installed on the
machine. The shared features are as follows:

Current blade life in hours

Error message (bottom of page)

Cut Piece Reset - Reset all Cuts Finished data by
pressing this button for three seconds.
If you start a new set of program without
clearing cutoff data from previous job, the first cut
(trim cut) will be skipped as the second program is
deemed as the succeeding part of the previous
program.

All Reset - Reset all preset cutting data within
Starts Step and Ends Step by pressing this button
for three seconds.

Blade Life Reset - Reset the blade life to zero
Page 49 Instruction Manual for C-320NC (B090) 08/11/2018