Cosen C-320NC, Инструкция по эксплуатации

Страница: 43 / 166

4-7
Blade Descend Pressure and Speed
The part of control panel is where cutting pressure and saw bow descend speed can be adjusted.
Cutting pressure and speed control panel
1. Cutting pressure control knob

This pressure control knob is used to adjust
the cutting pressure of the blade.

Turning the knob clockwise increases the
cutting pressure.

To obtain a good cutting result, choose the
right cutting pressure by turning the knob
until it points to your material on the color
chart.
2. Blade descend speed control knob

This knob is used to adjust the descend speed
of the saw blade.

Turning the knob clockwise increases the
blade descend speed.

Blade descend speed is a determining factor
to a good cutting time and quality cutoff
surface.

Set the blade descend speed in accordance
with the
cutting pressure control knob.

Also commonly known as the flow control
valve
Human-Machine-Interface (HMI) Touch Screen
This HMI touch screen displays operation messages so that the operator is able to understand the
system condition. It also provides different operating modes and selections for the operator to work
with. During a cutting job, the operator can still enter the system and make changes to the cutting
operation as needed.
Do not wipe or clean the screen with volatile solvents.
Do not overexert pressure on the screen. The touch screen is very sensitive; all buttons on the
screen just need a slight touch to operate.
All range parameters in HMI are configured under the “m anual ” mode.
Please pay attention to the following environment conditions necessary for HMI touch screen
to properly operate:
Page 43 Instruction Manual for C-320NC (B090) 08/11/2018