Corsa OSMOTIC ZERO, Инструкция по эксплуатации

Страница: 14 / 22

9. INSTALLATION
STEP 4
Install the 5-way valve into
the cold water tube (between
the house tap and the mains
intake)
STEP 1
Drill a hole in the sink
top using a 19mm bit.
STEP 2
Pass the tap
through this hole.
STEP 3
Assemble the tap with the
elements shown in the
figure and in the
same order.
STEP 6
Install the clamp for the equi-
pment drain outlet.
STEP 10
Connect the water outlet on
the back of your equipment
marked with to the tap of
your Osmotic Zero through
the white 1/4 “pipe
STEP 8
Connect the water recovery
(blue 5/16” pipe) to the
5-way valve at the recovery
outlet of the equipment
marked with
STEP 9
Connect the drain to the sa-
fety outlet of your equipment
marked with through the
red vinyl pipe
STEP 7
Connect the 5-way valve
intake (blue 1/4” pipe) to the
equipment inlet connector
marked with
STEP 11
Make the plumbing connec-
tions to the equipment and
afterwards connect it to the
electricity supply.
STEP 5
Drill a hole in the sink drain
with a 7.2 mm bit.
The cabling used for the electronic circuit must be supplied by the manufacturer. Under no circumstances
may extensions be used.
14