40
312026000
MENU SELECTIONS
MESSAGE DISPLAY
(EXAMPLE READOUTS)
“CLOCK” (TIME OF DAY)
see note below
C
_
1
2
-
0
0
A
“DEFROST” (AUTOMATIC)
3
D
1
0
-
0
0
A
“SLEEP” (SLEEP TIME)
S
1
2
-
3
0
A
_
“WAKE UP” (WAKE UP TIME)
W
_
0
7
-
1
5
A
“VIS SET” (PRODUCT VISCOSITY SETTING)
1
2
_
_
_
_
1
0
“VIS READ” (ACTUAL VISCOSITY READOUT)
1
6
_
_
_
_
1
1
“SENSORS (TEMPERATURES READOUT)
7
5
*
7
5
*
7
5
“VOLTAGE” (DISPLAYED VOLTAGE READOUT)
V
R
M
S
*
2
3
0
“DIAGNOSE” (DIAGNOSTIC MODE)
See Programming Components Diagnose into
Unit.
“TOTALS”
See Table 7 and programming “TOTALS”
(DISPLAYED CYCLES AND HOURS TOTALS)
into unit.
“MOTORS” (BEATER MOTOR MANUFACTURER)
See Table 5
“REF TYPE” (REFRIGERANT TYPE)
See PROGRAMMING PROPER
REFRIGERANT TYPE INTO UNIT
ELECTRONICS
NOTE: the “CLOCK” (TIME OF DAY) must be programmed into the Unit before “DEFROST”
(AUTOMATIC) “SLEEP” (SLEEP TIME), and “WAKE UP” (WAKE UP TIME) will function.
TABLE 3. MAIN MENU SELECTIONS
ADJUSTMENT AND PROGRAMMING MAIN MENU SELECTIONS INTO UNIT
Note: The Unit control panel switches are as shown in Figure 9.
The following instructions outline adjustments and programming main menu selections, components
‘‘DIAGNOSE’’ (DIAGNOSTIC MODE), and ‘‘TOTALS’ (DISPLAYED CYCLES AND HOURS TOTALS) into the
Unit.
NOTE: Plain water, CO
2
and syrup supplies to Unit must be satisfied to turn off ‘‘H
2
O OUT’’, ‘‘CO
2
OUT’’, ‘‘SYRUP 1’’, and ‘‘SYRUP 2’’ fault messages on message display before adjustments and
programming procedures can be performed on the Unit.
PROGRAMMING MAIN MENU SELECTION ONTO MESSAGE DISPLAY
The MAIN MENU SELECTIONS (see TABLE 3) may be brought up on the message display as follows:
1. Press ‘‘AUTO 1’’, ‘‘WASH 1’’, and ‘‘BLEND 1’’ control switches (see Figure 9) at the same time and hold
them pressed for a minimum of 1/2 second to bring up MAIN MENU SELECTIONS on message display.
The word ‘‘CLOCK’’ will appear on display. You are now in the MAIN MENU SELECTIONS as shown in 3
To advance through the MENU SELECTIONS, repeatedly press the ‘‘CANCEL DEFROST’’ (ADVANCE)
switch. Once you reach the desired selection, press the ‘‘DEFROST’’ (SELECT) switch to lock in on the
selection.
NOTE: To exit MENU SELECTION and go back to MAIN MENU SELECTIONS, press ‘‘ERROR RESET’’
(RESET) switch. Press ‘‘ERROR RESET (RESET) switch again to exit from MAIN MENU SELECTIONS.
SETTING CLOCK (TIME OF DAY)
NOTE: The CLOCK (TIME OF DAY) must be programmed into Unit before ‘‘DEFROST’’ (AUTOMATIC),
‘‘SLEEP’’ (SLEEP TIME), and ‘‘WAKE UP’’ (WAKE UP TIME) can be programmed into the Unit.
Содержание FCB 3 H.P. POST-MIX DISPENSER
Страница 23: ...16 312026000 THIS PAGE LEFT BLANK INTENTIONALLY...
Страница 69: ......
Страница 70: ...62 312026000 FIGURE 17 WIRING DIAGRAM 3584 Rev C...