CORN MACDON C HARVESTEC 6000, Руководство по установке

Страница: 16 / 24

3.
For narrow row heads, drill a 1
-
1
/
4
” hole
in front of hood
•
May also be used on wide row heads if desired
4.
Route PFB
6
through center of hood
•
Place clamp holding wire at front of hood
•
Connector should hang out of hole at rear of hood
•
Install grommet in front hole
5.
For narrow row heads, remove black Weatherpack connector from extension harness.
6.
From under head, route up thru wire guard installed above.
•
Pull
12
” or so thru the guard
7.
Reinstall the plug on extension harness.
•
Make sure to install the wires into the correct positions.
8.
Connect extension harness to PFB
6
•
Ensure connection is properly aligned and
seated until you hear or feel a slight click
•
Run zip-tie around connection and pull tight
•
Tuck connection inside hood
9.
Route wiring to rear of header
•
For wide row heads, route wiring through
existing hole to rear of header
•
Make sure to adequately clamp wiring
to prevent rubbing or pinching
•
If necessary, route wiring through a steel conduit to
protect it from debris–especially on chopping headers
•
Route to left of combine feederhouse
•
Secure wiring with cable clamps and zip ties
approximately every
12
–
24
” as needed
10.
Repeat steps above for each sensor.
11.
Wrap and fasten excess wiring in secure location.
12
In
st
al
la
tio
n