CORN MACDON C HARVESTEC 6000, Руководство по установке

Страница: 14 / 24

Routing Wiring - End Rows - MacDon
1.
Lay out wiring to appropriate snout.
• Wiring will run from the sensor to the rear of the header near the combine’s
feederhouse connection
• See the Harness Length Table
• Use a PFB
6
& an extension harness for each snout.
2.
If routing wire thru snout, raise the snout to
transport position and locate the hole on
the left side at the back of the snout.
•
Mark
4
¼ inches
•
Mark
5
-
3
/
8
inches off steel hood bracket.
•
Drill a
1
¼” hole at location and route
PFB
6
harness through the snout
3.
Connect PFB
6
to the sensor.
•
Ensure connection is properly aligned and seated
•
Push gently but firmly until you hear or feel a slight click
4.
If routing wire along bottom of snout, fasten wiring
with cable clamps on both sides of the connection.
•
Allow slight (½”) slack near sensor
•
Fasten off to side of snout to prevent damage
from sensor arm movement
10
In
st
al
la
tio
n