Cormach TOUCH MEC 100, Руководство по эксплуатации и обслуживанию

Страница: 36 / 57

Use and Maintenance Manual – 08/2018 Rel. 4 Page 31
When MOTO wheel type is active, ALU1 Program Type is selected automatically; if you try to select any other the machine will display
error code ERR 043.
To acquire automatically the geometrical wheel data by Distance/Diameter and Width sensors, it is necessary to keep the same
reference points on the rim as Program Type ALU1. Furthermore, when the Wheel Type MOTO is selected, the actual distance value
is increased of 150 mm due to the extension length for the Diameter/Distance sensor. Every time the flange for motorbikes is taken
down (for example, to balance wheels for vehicles) and then put back in, it is always necessary to line up the “CAL” markings on the
flange and flange for motorbikes. If this is not observed, balancing precision may be compromised.
16.3 Entering wheel dimensions
The dimensions of the wheel requiring balancing can be entered automatically.
Note: all the machines are equipped with a graduated scale for manually measuring the distance.
16.3.1 Automatic acquisition of the wheel dimensions for the STD Program Type
To acquire the wheel dimensions, proceed as described below:
Ph.
1
Fit the wheel on the shaft and tighten with the ring nut.
2
Take out first the width sensor
and THEN the distance/diameter
sensor and place them on the rim,
as shown here.
When the both sensors come back
in rest position, it is automatically
activated the STANDARD program
.
3
Wait to hear the long acquisition
beep and then set the sensors
back to the rest position. During
acquisition the distance and
diameter values are displayed on
the wheel dimension data band.