42
Artiglio 50
- Kit PAX System
Positioning the tool
Fig. 28 - (assembly of upper part)
- Lubricate the seats of the beads on
the rim (areas indicated by the "T" in
fig.28).
- Insert the tyre cover/support assembly
on the rim fig.28.
- Position the assembly tool as shown in fig-
ure 29, so that you can work on the upper
part of the tyre cover. Fix the tool to the
arm, using the outer hole - fig 6a.
- By means of the pneumatic command
device, lower the arm with the cylindrical
roller (fig. 29) until it is near the edge of
the upper rim.
- Position the roller manually on the outer
edge of the rim, and block the arm in place
by means of the selector - fig. 29A.
28
T
29
29A
Assembling the support on the
rim
(Procedure for Pax System with full-width
support)
- Press the roller against the bead of the
tyre and, at the same time, rotate the
turntable until the support (S) is com-
pletely inserted in the rim (T) - fig.27a.
- Once the operation is completed, raise
the roller from the tyre.
Assembling the support on the
rim
(Procedure for Pax System with clipped
support)
- Move the arm along the axis, using the
pneumatic lever, until the roller is in line
with the rim - fig 30.
- Move the bead of the tyre away, and
bring the roller down to the surface of
the support - fig. 31.
- Rotate the turntable until the support
(S) is completely inserted in the rim (T)
fig.27. At the end of this operation, lift
the roller from the tyre.
N.B.:
the support is completely inserted when
you hear the resonant signal caused by
the fixing in the appropriate seat.
ATTENTION
