Direct Connect (USB)
MN4000 Cameras can be configured via the
chassis in Direct Connect Ethernet mode or
when installed and in use, via Direct Connect
USB mode, this is the recommended mode of
communication for initial setup.
To communicate via Direct Connect USB, first
ensure the MN4000 is powered up and the
PC running MONITIR Application is connected
to the USB port located on the front of the
camera.
Direct Connect (Ethernet)
Both MN4000 and MN4100 have the capability
for a direct, PC to Camera Ethernet connection
using the MONITIR PC Application. Direct
Connect (Ethernet) is the recommended initial
setup mode for MN4100 cameras as they are
shipped with a factory set static IP address.
To communicate with the camera, ensure
the PC running the MONITIR Application is
connected to the camera with an Ethernet
cable, then click the Direct Connect (Ethernet)
icon from the homepage.
Then click the Direct Connect (USB) icon
from the home screen and the Application
will communicate directly with the camera,
displaying returned data in the following
format.
If this is a first time setup of an MN4000, type
192.168.1.100 into the Ip address box and click
Connect. If this is not a first time setup, you
must type the Ip address associated with your
specific camera.
RUGGED
AUTHORITY
MONITIR Series Thermal Imaging Cameras
– User Manual
25
Document Reference MONITIRSERIESUM Rev. A
