3
(617417440)
FM359 7/19
Access 800
™
Series
Locks
Keypad Programming Instructions
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2018
-2019
Corbin Russwin, Inc., an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
2
General Programming
To Begin Programming:
The Lock Controller is preset at the factory with
Master Code “1234”.
It is strongly recommended
that the Master Code be changed as the first
programming step.
Entering 1234 * will unlock
the lock allowing the lever handle to retract the
latchbolt.
Initial Set-Up Procedures:
•
The following are typical procedures to be used
when setting up your Access 800 lock.
•
If a mistake is made during any of procedures,
depress the “*” key several times until the
yellow LED goes out.
•
If no keystroke is made in a 30 second time
frame, the programming up to that point will
default and you will have to start over.
Lock Model: _______________________________
Door Name: ________________________________
Location: __________________________________
*Note: If memory is cleared, you must reprogram Emergency code. The Master code resets
back to 1234*.
3
Individual Door Log Sheet for Keypad Programming
Main Codes - User Programmed “Door” Log
Function
User Location
Default Code
User Programmed Code
Master Code
01
1234&
Supervisor Code
02
User Programmed “Door” Log
User Name
User Type
User Location
User Code
Card/Fob#, Notes
Determine which programming steps to use
for your lock:
•
If your label has an M800, then use the
programming in Section 4. (Figure 1)
•
If your label has an M801, M803, M804, or
M806, reference programming in Section 5.
(Figure 2)
•
If your label has a M802 or M805,
Accessware™ application Software must
be used for programming. See Section 7.
(Figure 2)
Figure 1
Figure 2
M80X
White Button
M800
Grey Button
