PAGE 9
A PRODUCT OF
THE CORAM GROUP OF COMPANIES
Coram Showers Limited
Stanmore Industrial Estate
Bridgnorth
Shropshire WV15 5HP, UK
www.coram.co.uk
CARE AND MAINTENANCE
IMPORTANT: When silicone sealant is used you must not use or work on the enclosure
for 24 hours after installation.
DO NOT use bleach, scouring powders, solvents or other aggressive cleaning agents.
To clean use warm soapy water and a clean cloth and rinse off.
Periodically check all fixings and tighten if necessary.
CUSTOMER CARELINE:
01746 713410
25
From outside only, apply silicone sealant along the bottom of the panels as shown.
24
Push-fit the top caps onto the wall channels.
Outside
RECYCLING
Packaging: The cardboard and polythene parts of this packaging can be recycled
End of life: This product contains materials such as aluminium and glass which can be recycled
Please contact your local authority to find your nearest recycling centre
22
Place the second wall channel in position against the wall.
a:
Ensure the wall channel is vertical and mark the four holes onto the wall.
b:
Drill the four positions marked using a 6mm drill bit.
c:
Apply silicone sealant to the back of the wall channels
d:
Insert the wall plugs. Place washers over the 32mm screws and fix the wall
channel to the wall. If necessary, slight adjustment is available in the wall channel.
ø 6
mm
a
b
d
32
mm
24
Carefully push the panel into the wall channel.
Note: Wetting the edge of the panel with water will
help the panel insert.
23
Slide both seals down into the wall channel and cut
off any excess.
Note the orientation of the soft flippers.
c
IMPORTANT
Ensure Glass Guard H2o
label is to the outside of
the enclosure/panel
Satin glass patterns must
be installed to the outside
of the enclosure.
Note:
The Glass Guard coating
is on the opposite side
to the label or satin glass
patterns
Now attach the Vertical
strut to the second panel,
repeating steps:
17 - 21
