14
PAGE 7
16
From outside only, apply silicone sealant along the bottom of the panels as shown.
13
a:
If required, trim the strut to length:
Y + 86mm.
b:
Push-fit the end cap onto the untrimmed end of the strut.
a
b
Y + 86mm
Untrimmed
end of strut
15
Push-fit the top caps onto the wall channels.
Outside
12
Ensure that the end of the second panel is vertical.
Carefully place the second panel bracket on to the glass, approximately 100mm from
the edge (depending on your installation).
Carefully measure the distance
‘Y’ between the wall bracket assembly and the panel
bracket.
Y
Position the strut into the wall bracket assembly
and the panel bracket.
Ensure the panel is vertical and tighten the grub screws onto the strut bracket using the
3mm Allen key.
Approx.
100mm
1
2
Inside
