4) CAM NUM: CH1 – CH16
AREA SETTING : DISABLE/ ALL/ SETUP
Motion Enable/Disable, Motion zone can be selected separately for each of sixteen
cameras using
LEFT
or
RIGHT
button.
DISABLE
means that function of motion detection isn’t utilized.
ALL
means that entire image area is selected for motion detection.
SETUP
can be selected in order to select given image area which want to monitor
motion detection. Total motion area consists of 14x10 blocks. To select arbitrary motion
zone, select
SETUP
using
LEFT
or
RIGHT
button. And then press
ENTER
button to
designate motion areas in 14x10 blocks. You can use
LEFT
or
RIGHT
button for
horizontal movement
UP
or
DOWN
button for vertical movement,
ENTER
button for
selection. You can define the area of the image where you don’t want to detect motion.
Selected blocks in 14x10 blocks will be blinking. To remove previously defined image
block for motion detection, press
ENTER
button again at that block. After defining
motion zone, press
ESC
button to return upper Menu. Motion detection zone is
the area which edge of the motion blocks is not flickering.
< The example of motion area setup >
TRIGGER OUT: DISABLE/ 1 to 4
It is supported to output alarm output (relay output) when motion is detected.
In case that relay output isn’t requested, it can be set “DISABLE”. When motion is
detected in some of video channels, relay output 1 to 4 can be selected to support relay
output. Trigger output for motion detection in CH02 can be designated as “trigger
output 1”. Trigger output for motion detection in CH10 can be designated as “trigger
output 3”.
5) BUZZER ALERT: DISABLE/ ENABLE
If motion be detected in motion area, beep sound from buzzer by
BUZZER ALERT
with
ENABLE
would be occurred during two seconds.
PDF created with pdfFactory trial version
www.pdffactory.com
