![background image](http://html1.mh-extra.com/html/coopers/victor-garden-tools-9806/victor-garden-tools-9806_instructions-manual_2665221003.webp)
Victor Garden Tools
USING THE LAWN MOWER
WARNING
For safety reasons persons of less than 16 years of age or persons not
familiar with these operating instructions must not use the lawn mower.
This mower is designed for use on residential lawns. It is not designed
for commercial use or for use in public facilities, parks, sporting grounds,
roads, or in agriculture or forestry areas.
This mower is for cutting lawns only. It must not be used to trim hedges,
bushes or shrubs, for cutting or pruning, or for any mowing where both
wheels and the roller are not fully supporting the mower.
Damage to blades or other parts of the machine caused by
stones or other debris being “mown” up will not be covered
under this warranty! Always ensure the work area is clear
before use.
PARTS LIST
Please check when
unpacking the unit to be
sure that all items listed
below are included:
1. Main unit
2. Safety switch
3. Lever switch
4. Battery pack
5. Grass catcher
6. Upper handle
7. Middle handle x2
8. Lower handle
9. Nuts and bolts x8
10.Charging adaptor
11. Height adjustment knob
12. Cable clips x3
13. On/Off switch
14. Reset button
ASSEMBLY
Unpack and remove the whole mower from
packaging, and ensure all the parts are present.
CAUTION: remove the battery before
assembling the unit.
1. Set the cutting height to the highest setting.
This will make it easier to attach the Lower
handle section (8). It is easiest to fit the handle
when the mower is flat on the ground and the
handle is in a perpendicular position.
2. Fit the Lower handle (8) onto the two large
lugs on the Main unit (1). Fit one side and then
flex the other side of the handle until it fits the
opposite lug. (See Figure 2).
3. Assemble the Upper handle (6) to the Middle
handle (7). Use two sets of the nuts and bolts
(9) to secure in place. Make sure that the Upper
handle (6) is facing up (safety button facing up)
(see Figure 3). If you have incorrectly assembled
this part, disconnect and re-assemble in the
correct orientation.
4. Use two sets of the nuts and bolts (9) to
assemble the Upper and Middle handle
assembly to the Lower Handle (8). The nuts
should be positioned on the inside of the
handle and the bolts on the outside.
(See Figure 4)
5. Once the Handle is assembled connect the plug on the handle
cable to the socket on the Main unit. Tighten the screw ring to
secure the cable. (See Figure 5)
6. Secure the cable to the handle using the three cable clips.
(See Figure 6)
7. Attach the Grass catcher to the mower base Note: This mower
can be used with or without the Grass catcher.
Step 1: Place the two Grass catcher side bars onto both sides of the Grass catcher Hooks
as shown in Figure 7.
Step 2: Wrap the Security Belt, located on the
back of the Grass catcher, around the
centre joint of the Lower handles and lock
buckle into place, as shown in Figure 8.
Note the length of the Security Belt can be
adjusted by modifying the loop length.
(See Figure 8)
Figure 8
Figure 7
Figure 6
Figure 5
Figure 4
Figure 3
This side up
Figure 2
Lower
handle
Lug